Type of Error	Status
Naming convention followed?	No
Error in textbook mentioned as comment?	No
Problem statement included in code?	Yes
Axes labeled?	No
Symbols used are appropiate?	Yes
Scilab functions used?	Yes
Solved using Matlab in textbook?	No
Appropriate comments included as mentioned in checklist point 7?	Yes
Appropriate units used as given in the textbook?	Yes
Typographical errors in output and/or comments?	Yes
Answers matching with the textbook?	No
Any Other Comment?	No space between answers in the output. The answer to the second subpart is outside the required error percentage according to the answer in the textbook.

clc //initialization //positive stress is tensile and negative stress is compressive p1=40// N/mm^2 (Tensile stress in the material) p2=-30//N/mm^2 (Compressive stress in the material on a plane at right angles to p1) q=20// N/mm^2 (Shear stress in the material on the same planes) pperm=100//N/mm^2 (Permissible direct stress in the material) qperm=70// N/mm^2 (Permissible shear stress in the material) //calculation Sig1=(p1+p2)/2+sqrt(((p1-p2)/2)^2+ q^2)//N/mm^2 (Maximum principal stress) Sig2=(p1+p2)/2-sqrt(((p1-p2)/2)^2+ q^2)//N/mm^2 (Minimum principal stress) ptmax=(Sig1-Sig2)/2//N/mm^2 (Maximum shear stress) //Given: k= factor by which the stresses are increased //Given condition 1: Sig1*k1 should not exceed pperm so k1 = pperm/Sig1 //Given condition 2: ptmax*k2 should not exceed qperm so k2 = qperm/ptmax //Permissible value of k will be minimum of k1 and k2 k1=pperm/Sig1//unitless(Maximum value of k applying given condition 1) k2=qperm/ptmax//unitless(Maximum value of k applying given condition 2) k=min(k1,k2)//Permissible value of k is minimum of k1 and k2 //results printf('Maximum value of k applying given condition 1= %f',k1) printf('Maximum value of k applying given condition 2= %f',k2) printf('Permissible value of k = %f',k)